fbpx
Adventures In Audio with Audio Masterclass
Recording SoftWare for Blind people. Can anybody Please help?

Hands On – Casio DA-7 (part 3)

FREE EBOOK DOWNLOAD ►

That was the full length version. Once you have set your levels, it is easier
to initiate recording by pressing Record, then Play immediately after. As with
all DAT recorders you are recommended to allow the tape to roll for at least
fifteen seconds (some would say thirty) before you start your source material.
This is so that when you are copying digitally the destination machine has time
to lock up to the sampling rate of the source. If you don’t leave this
gap, you may be forced to copy via the analogue outputs, which is obviously
less than ideal.


The meter on the DA-7 reads from -50dB to ‘Over’ which you might
be inclined to take at face value. However, ‘Over’ really means ‘not
quite over yet’, so your recordings will end up being a little lower in
level than you might expect if you always play safe. I don’t get too excited
if the Over segment lights up occasionally. I always monitor the output anyway
and if it sounds OK then, to me, it is OK.

Start IDs

The ID codes on DAT are a great invention. The Casio DA-7 can implement Start
and End IDs but not Skip, which is a bit of a pity – I for one use them all
the time on my Sony DTC1000ES. In normal operation the DA-7 records Start IDs
automatically, which can be a big pain since your tape will end up peppered
with IDs in all the wrong places. Just by looking at the machine I doubt if
you will be able to figure out how to switch off the automatic Start ID insertion,
no matter how deeply you furrow your brow. But hidden in the manual is a valuable
piece of advice: while the machine is in Record Pause mode, press the Mode button.
This will switch the ‘Auto ID’ flag in the display off. What’s
more, you can still add IDs manually as you record by pressing the Play button
each time you want one. It’s a bit disconcerting to press the Play button
while you are in the middle of an important recording, but it inserts Start
IDs just like the manual says.


During the recording session, it’s likely that you will want to wind
back and listen to certain takes. Usually, you then have to be very careful
to go back exactly to the end of the last thing you recorded otherwise you might
erase something valuable. But if you started off with a new, unrecorded tape,
then the DA-7 will handle this for you. If you stop playback anywhere in the
recorded section of the tape and press the Fast Forward button, the machine
will stop automatically at the beginning of the unrecorded part of the tape.
This is particularly convenient but unfortunately it can only work with new
tape. If you are reusing an old DAT cassette which was formerly recorded right
to the end then there will be no unrecorded sections on the tape, therefore
the DA-7 will just wind straight to the end. If you are saying at this point
why not bulk erase the tape before use, yes this would be ideal but bulk erasers
that are powerful enough to erase high coercivity DAT tapes are extremely expensive.
Come on you manufacturers – make us a cheap DAT bulk eraser please!

Ebook = Equipping Your Home Recording Studio
FREE EBOOK - Equipping Your Home Recording Studio

David Mellor

Introduction to Audio Recording

Introduction to Audio Recording

You can't learn this type of info anywhere but here! Pro audio engineers share deep secrets about how they choose microphones for common recording situations.

Learn more...

Add comment








David Mellor

DOWNLOAD YOUR FREE GUIDE

DOWNLOAD YOUR FREE GUIDE

Free Download

WAIT! Do you know how to build the best home recording studio for the lowest cost?

Download our guide to ensure you make the right choices and get the best value for money

Your home recording studio should help you make great music

And save you money in the process!

With our free guide you’ll learn how to choose the best equipment and software to build your own first-class home recording studio