The first thing you are likely to want to do with your new DASH machine is
of course to make a recording with it, but it would be advisable to read the
manual before pressing record and play. Some of the differences between digital
and analog recording stem from the fact that the heads are not in the same order.
On an analog recorder we are used to having three heads: erase, record and play.
DASH doesn't need an erase head because the tape is always recorded to a set
level of magnetism which overwrites any previous recordings without further
intervention. So the first head that the tape should come across should be the
record head. Right?
Wrong. The first head is a playback head, which on an basic DASH machine is
followed a record head only. If this seems incorrect, you have to remember that
while analog processes take place virtually instantaneously, digital operations
take a little time. So if you imagine analog overdubbing where the sync playback
signal comes from the record head itself, you can see why this won't work in
the digital domain. There will be a slight delay while the playback signal is
processed, and another delay while the record signal is processed and put onto
tape. 105 milliseconds in fact, which corresponds to about 75 mm of tape. To
perform synchronous overdubs there has to be a playback head upstream of the
record head otherwise the multitrack recording process as we know it just won’t
work. For most purposes two heads are enough, and a third head is available
as an option if you need it, and you'll need it if you want to have confidence
monitoring. (There are no combined record/playback heads, by the way, all are
On any digital recording medium the tape has to be formatted to be used. On
DAT the formatting is carried out during recording, but on DASH it is often
better to do it in advance. The machine can format while recording – in Advance
Record mode – but this is best done in situations where you will be recording
the whole of the tape without stopping. If you wish, you can ‘pre format’
a tape but this obviously takes time. You can take comfort from the fact that
it can be done in one quarter of real time, and the machine will lay down timecode
Since there are different ways to format a tape and make recordings, the 3342S
has three different recording modes: Advance, Insert and Assemble. Advance mode
is as explained above. Insert is for when you have recorded or formatted the
full duration of the material and you want to go back and re-record some sections.
Assemble is when you want to put the tape on, record a bit, play it back, record
a bit more etc, as would typically happen in classical sessions.